How to prevent algae & ammonia in planted aquarium for a month?

When used as instructed, plant nutrients and fertilizers designed specifically for aquarium plants will not harm aquarium fish. Allow new aquarium plants to settle and establish themselves before adding any fertilizers. Use aquarium plant substrates such as CaribSea Eco-Complete Plant Substrate http://www.drsfostersmith.com/product/prod_display.cfm?pcatid=9087 to get your plants established faster. Seachem Flourish Advance Natural Phytohormone Supplement http://www.drsfostersmith.com/product/prod_display.cfm?pcatid=33890 will help stimulate root growth vital for overall plants health. Even though you have plants with low to moderate light requirements, be sure to use aquarium light specifically designed for planted aquarium use (sometimes called plant lights) and have the lights on between 10 and 12 hours a day. You may need to adjust the photoperiod (the amount of time the light is on) depending on how your plants are doing and to prevent unwanted nuisance algae growth.

The best and safest method is through daily partial water changes, about 30-40% of total tank volume. Use only aged or conditioned water that is temperature matched to prevent stress or shock. Recommended water conditioners are AmQuel, NovAqua and StressCoat. These can be purchased online or in most pet stores or fish stores. A home test kit should be used to monitor levels. If a tank is properly cycled, beneficial bacteria will break down these toxins. Overfeeding, excessive light or heat and dead plants can cause spikes in ammonia and nitrite levels.

The green you see is algae. These like nutrition-rich water and lots of light. So you are probably feeding your fish too much and they are not eating all the food. Also there may be too much day light reaching the tank. I suggest you cover your tank in such a way that most of the day light is removed. Fed your fish sparsely. That means, only feed what they can and will eat within one minute. Get some algae-eating fish like a small pleco. Also change about 1/3 to 1/2 of your tank water to remove some of the algae floating in the water.

It is possible the tank has not cycled properly which results in high ammonia and nitrite levels which can kill fish. Allow the tank to run, without fish, for at least 4-6 weeks. During this time, use a home test kit or submit a water sample for testing every few days. The local Petco may do this for free or for a small fee. What you are looking for is to have ammonia and nitrites at 0 ppm and nitrates at 20ppm or less. pH can hover around 7 for most community fish. Avoid large, rapid swings in pH though. What is happening in the tank during this time is that beneficial bacteria are populating the gravel/substrate and the filter. These bacterial populations are responsible for the Nitrogen Cycle. This cycle breaks down wastes from fish, uneaten food and plant matter into by-products that are filtered out or dissipate. You can "cycle" a tank with fish, however this increases the risk of loss. Once your tank has cycled, you can add fish. You will still need to monitor water chemistry and perform partial water changes regularly. Use only conditioned water that is temperature matched to prevent stress or shock. You will also need to vacuum the gravel regularly and rinse the filter media. Never use tap water to rinse. Use a bit of tank water to protect bacterial populations in the sponge.

Check the water chemistry using a home test kit or submit a water sample for testing. The local Petco may do this for free or for a small fee. Aim for an absence (0 ppm) of ammonia and nitrites with nitrates at 20ppm or less. Perform partial water changes to stabilize chemistry and/or to improve water quality. Rinse the filter media in tank water, not tap water, and replace it. Use only conditioned water that is temperature matched to prevent stress or shock. To limit algae growth, maintain pristine water quality via filtration and regular water changes. If possible, turn up filter flow to keep water moving. If this stresses the fish though, do not do it. Do not overfeed and remove any uneaten food promptly. Limit lighting to 8 hours daily and closely monitor water temperature as well. All these can promote algae overgrowth.

Thanks for using Petco Pet Education Center, formerly Petcoach! You can probably extend it to one month if you are doing water changes that often. I would recommend you extend it to 3 weeks first. If that goes well then extend it to 4 weeks to see how it goes. You can then decide how long you can let it go before cleaning. Best of luck!

Yes, you can rinse filter media (the sponge) using tank water. This will preserve beneficial bacterial populations in the sponge. The plastic filter parts can be rinsed and scrubbed using tap water. Perform a partial water change, no more than 30% total volume, using conditioned water that is temperature matched. To limit algae overgrowth, do not overfeed, limit lighting to 8-10 hours daily and monitor water temp. If possible, turn up filter flow to get the water moving. Algae thrives in slow moving water. Do this only if your fish are not affected by stronger currents.